When a companion WiFi device has no WiFi credentials or can't connect for
60s, it broadcasts an 'EastMesh-WiFi' AP (WPA2 password = device pin
zero-padded to 8 digits; open if no pin set) with the rescue CLI on TCP
port 23, so wifi.ssid/pwd can be fixed without a serial cable.
- rescue CLI command handler now writes to any Stream (Serial or the TCP
rescue client)
- while the AP is up, STA keeps retrying; the AP shuts down automatically
once the configured network connects
- 'set wifi.ssid/pwd' keeps AP+STA mode during a rescue session so the
session isn't dropped mid-config
- guard ESP32-only SD/SPI code in ArchiveStorage so non-ESP32 builds of
the shared helpers get further
Co-Authored-By: Claude Fable 5 <noreply@anthropic.com>
Integrates upstream v1.17.0. Key adaptations:
- companion + repeater NodePrefs moved to upstream's new ConfigSerializer
(prefs.json) format; EastMesh fields (companion wifi, repeater fan and
MQTT bridge peer) appended as serializer groups/keys
- legacy binary prefs loaders retain EastMesh tail fields, so existing
devices migrate their settings to the new format
- companion main.cpp adopts upstream InterfaceManager while keeping
runtime WiFi credentials from prefs
- kept EastMesh release-tag versioning in setup-build-environment action
Co-Authored-By: Claude Fable 5 <noreply@anthropic.com>
The room server never supported RX boosted gain, while the repeater
does. Three consequences on SX1262/SX1268 boards:
- boosted gain was never applied to the radio at boot, so a room server
ran in power-saving RX mode while an identical repeater ran boosted -
a real receive-sensitivity difference with nothing pointing at it
- _prefs.rx_boosted_gain was never initialised (the prefs are memset to
0 before defaults are set), so it defaulted to off
- 'set radio.rxgain on' replied "Error: unsupported" but CommonCLI had
already written the value to prefs and saved them, so a stale setting
survived reboot and was never applied
Mirror the repeater's implementation: initialise the pref default under
the same USE_SX1262/USE_SX1268 and SX126X_RX_BOOSTED_GAIN guards, apply
it during radio init, and override setRxBoostedGain() so the CLI reports
success and takes effect.
Built Heltec_v3_room_server (SX1262) and LilyGo_T3S3_sx1276_room_server
(guards compile out cleanly).
setTxTimeoutMs() and setTxBufferSize() are HWCDC-only APIs; calling
them on HardwareSerial (UART-bridge boards like T-Beam) fails to compile.
Co-Authored-By: Adam Gessaman <adam@gessaman.com>
Switch ESP32-S3 KISS modem environments to HWCDC and move outbound KISS writes to a non-blocking queued frame path so loop() and TX completion keep progressing when the host reads slowly. Add native backpressure regression tests and correct the native_kiss_modem test filter so this suite runs directly with pio test.
