When a companion WiFi device has no WiFi credentials or can't connect for
60s, it broadcasts an 'EastMesh-WiFi' AP (WPA2 password = device pin
zero-padded to 8 digits; open if no pin set) with the rescue CLI on TCP
port 23, so wifi.ssid/pwd can be fixed without a serial cable.
- rescue CLI command handler now writes to any Stream (Serial or the TCP
rescue client)
- while the AP is up, STA keeps retrying; the AP shuts down automatically
once the configured network connects
- 'set wifi.ssid/pwd' keeps AP+STA mode during a rescue session so the
session isn't dropped mid-config
- guard ESP32-only SD/SPI code in ArchiveStorage so non-ESP32 builds of
the shared helpers get further
Co-Authored-By: Claude Fable 5 <noreply@anthropic.com>
Integrates upstream v1.17.0. Key adaptations:
- companion + repeater NodePrefs moved to upstream's new ConfigSerializer
(prefs.json) format; EastMesh fields (companion wifi, repeater fan and
MQTT bridge peer) appended as serializer groups/keys
- legacy binary prefs loaders retain EastMesh tail fields, so existing
devices migrate their settings to the new format
- companion main.cpp adopts upstream InterfaceManager while keeping
runtime WiFi credentials from prefs
- kept EastMesh release-tag versioning in setup-build-environment action
Co-Authored-By: Claude Fable 5 <noreply@anthropic.com>
Board manifest for esp32-c6-devkitm-1 defaults build.flash_mode to qio,
which this module's flash chip does not support -- causes a boot
crash-loop (repeated USB-Serial-JTAG reconnects) on real hardware.
Override with board_build.flash_mode = dio in the common M5Stack_Unit_C6L
section so it applies to all envs (ble/usb/repeater/room_server).
CustomLR1110::startReceive() passed RADIOLIB_LR11X0_IRQ_PREAMBLE_DETECTED
(1<<4 = 16) as RadioLib's first argument, which is the RX *timeout*, not an
IRQ mask. At the LR11x0's 30.52us tick that armed the receiver for ~488us, so
it dropped out of RX before any packet could arrive and the node received
nothing at all -- while transmitting normally.
Symptoms on a SenseCAP T1000-E: tx_air_secs rising, rx_air_secs stuck at 0,
recv_errors 0, and the noise floor pinned at the -120 clamp because
getCurrentRSSI() never sampled a live receiver.
Pass RADIOLIB_LR11X0_RX_TIMEOUT_INF (continuous RX), which is what
LR11x0::startReceive() itself uses, keeping the PREAMBLE_DETECTED flag in the
reported IRQ flags as intended.
Introduced in ea5d7c8b ("LR1110: add PREAMBLE_DETECTED to reported irq flags").
Verified on two T1000-E units: with only the repeater fixed it began receiving
(last_rssi -29, SNR 17.0) while the unfixed companion stayed deaf; fixing both
brought up the link in each direction.
If Bluefruit.begin fails, BLE OTA mode won't actually start and the board might require a reboot to reattempt.
Fixes:
- Bluefruit.begin returns false in NRF52Board.startOTAUpdate if OTA mode fails to start. User is notified of the fault through existing error message in CommonCLI and can reattempt "start ota" command.
