MeshCoreTel-firmware/variants/rak3401/RAK3401Board.cpp

#include <Arduino.h>
#include <Wire.h>

#include "RAK3401Board.h"

void RAK3401Board::begin() {
  NRF52BoardDCDC::begin();
  pinMode(PIN_VBAT_READ, INPUT);
#ifdef PIN_USER_BTN
  pinMode(PIN_USER_BTN, INPUT_PULLUP);
#endif

#ifdef PIN_USER_BTN_ANA
  pinMode(PIN_USER_BTN_ANA, INPUT_PULLUP);
#endif

#if defined(PIN_BOARD_SDA) && defined(PIN_BOARD_SCL)
  Wire.setPins(PIN_BOARD_SDA, PIN_BOARD_SCL);
#endif

  Wire.begin();

  // PIN_3V3_EN (WB_IO2, P0.34) controls the 3V3_S switched peripheral rail
  // AND the 5V boost regulator (U5) on the RAK13302 that powers the SKY66122 PA.
  // Must stay HIGH during radio operation — do not toggle for power saving.
  pinMode(PIN_3V3_EN, OUTPUT);
  digitalWrite(PIN_3V3_EN, HIGH);

  // Enable SKY66122-11 FEM on the RAK13302 module.
  // CSD and CPS are tied together on the RAK13302 PCB, routed to IO3 (P0.21).
  // HIGH = FEM active (LNA for RX, PA path available for TX).
  // TX/RX switching (CTX) is handled by SX1262 DIO2 via SetDIO2AsRfSwitchCtrl.
  pinMode(SX126X_POWER_EN, OUTPUT);
  digitalWrite(SX126X_POWER_EN, HIGH);
  delay(1);  // SKY66122 turn-on settling time (tON = 3us typ)
}

#ifdef NRF52_POWER_MANAGEMENT
void RAK3401Board::initiateShutdown(uint8_t reason) {
  // Disable SKY66122 FEM (CSD+CPS LOW = shutdown, <1 uA)
  digitalWrite(SX126X_POWER_EN, LOW);

  // Disable 3V3 switched peripherals and 5V boost
  digitalWrite(PIN_3V3_EN, LOW);

  enterSystemOff(reason);
}
#endif